not rated £175.00 – £181.34 Select options
Hydroforce In-Line Sprayer (AS08)
The Hydro-Force Injection Sprayer is based upon an injection system that consists of a specially designed valve that injects a concentrated chemical into the high-pressure water flow from the machine. Hydro-Force is designed for use with incoming water pressure of 400 PSI. The water flow is automatically reduced as it passes through the injector valve, thus reducing the pressure approximately 64%. To obtain the actual working pressure of your Hydro-Force Injection Sprayer, multiply your incoming pressure by 36%. The Hydro-Force Injection Sprayer is factory set to inject chemicals at a 1 to 8 ratio. Other chemicals may be used but should be prepared for a 1 to 8 dilution. The Hydro-Force pressure can be increased by putting a smaller jet at the end of the wand. This will, however, decrease the injection rate of your chemical. Your injection ratio may also change depending on the viscosity (thickness) of your chemical concentrate. The 1 to 8 ratio is based upon chemicals with a similar viscosity to water. The injection ratio can also be slightly affected by your main flow water temperature. This is generally not enough of a change to appreciably change the effectiveness of your system. We do, however, recommend the water temperature be kept below 200 degrees Fahrenheit, as higher temperatures can cause problems on the injection. Supplied with either male or female solution coupling.
Refillable Premium Misting Bottle
A fine misting bottle, ideal for applying cleaning solution or protector to upholstery and fine fabrics without over-wetting the fabric. The misting spray bottle is strong, lightweight and refillable. You can even use the misting bottle upside down and it will still provide a sustained spray. Easier to use than a conventional trigger spray and more eco-friendly than an aerosol. Available in 200ml or 300ml sizes, colour may vary.
Misting bottles are great for sanitiser!Use with our Envirosafe or Envirosafe Food Safe - Anti-microbial, anti-bacterial, anti-viral and anti-fungal. For use on all wet cleanable carpets, fabrics and hard surfaces wherever virus and bacteria control is required. Ideal for small space fogging and surface sanitisation. Spray lightly and evenly over surface. Leave product to dry, do not wipe or rinse off. Avoid non-wet cleanable surfaces and fabrics (ie dry clean only) matt paint and other sensitive surfaces - if in doubt pre-test in an inconspicuous area, allow to dry and check suitability before proceeding with full sanitisation. Use with our QAC Test Strips for effective measuring of product efficacy, see here.
Avoids Over-wetting.The sprayer is great for work that requires a a consistent spray of fine mist. Perfect for cleaning upholstery or fine fabrics where over-wetting is a concern. By squeezing the trigger you "prime" the sprayer and can spray continuously without breaks in spraying like a standard trigger sprayer. - Just Prime, Aim and Spray - No Solvents or Pressurised Gases - Gives a Consistent Aerosol Type Mist - Safe for the Environment.
Rated 4.90 out of 5£3.50 – £4.50 Select options
not rated £204.54 – £210.88 Select options
Hydroforce Revolution In-Line Sprayer (AS08R)
The original Hydroforce Revolution injection sprayer (100 - 1,000 PSI) For those that want to revolutionise how their spraying is done, the Revolution in-line sprayer takes efficiency to a new level by allowing cleaners to adjust dilution ratios on the fly. Gross traffic lanes? No problem! Blast away dirty spots with the turn of a knob. Avoid over wetting and cut your spray time in half! Quickly apply presprays, deodorizers, tile and grout cleaning solutions, sanitisers, protectors and more. Benefits:
- NEW, patent-pending container design makes the Hydro-Force in-line sprayer the most convenient sprayer on the market.
- Large side-fill port – refill without removing the injector assembly
- Wand holder to keep your wand off your customer's floor
- Recessed handle – no more annoying velcro straps
- Operating pressure range of 100-1,000 PSI*
- Eliminates annoying mixing required by pump up sprayers
- Adjust dilution ratios on the fly - don’t mess with metering tips!
- High-quality quick connects allow your gun to swivel and permits quick removal