A unique professional Colour Enhancing Impregnator, for greatly enhancing the colours in natural and man made tiles. Using the New Advanced Resin-Technology it produces an invisible, highly protective shield both within the stone and on the surface, helping to protect against both water & oil based spills.
With this amazing technology you will discover that your regular cleaning and maintenance will be considerably easier.
In addition, Colour Enhancing Impregnator uses natural oils and pigments, to intensify and enhance the stones natural beauty.
Colour Enhancing Impregnator can be used on terrazzo, travertine, sandstone, limestone, brick sets, york stone, amalgamated stone, slate, un-glazed ceramic tiles.
The product is particularly useful in kitchens, utility areas, bathrooms, shower rooms, dining rooms and all other areas where spillages may occur.
Amazingly, Colour Enhancing Impregnator is also superb for not only removing Efflorescence (white stains) from brickwork but also preventing the white stains from reappearing. The product seals the brickwork after removal but also allows the stone breath naturally.
PLEASE NOTE: Do not use Colour Enhancing Impregnator if applying Professional Slate Sealer, or any other sealer.
Approx. 5-8 sq mtrs per litre on highly absorbent surfaces.
Up to 15 sq mtrs on polished surfaces.
Up to 35 sq mtrs on very dense stones.
PRODUCT ADVICE: Ensure under floor heating is turned off and allow floor to cool prior to application. Test product for any colour change in an inconspicuous area before use.
On very porous surfaces, may be re-applied several times – Allow each coat to dry before applying additional coats
IMPORTANT: On polished surfaces; leave 5 – 10 minutes and wipe off, re-apply if required. DO NOT allow product to dry without wiping off.
DIRECTIONS FOR USE: Invert container before use – Ensure the area to be treated is clean and free from dust and dirt.
Using a clean dry cloth, applicator, sponge, brush or roller;
Apply a thin and even coat over the area to be treated, wait 30 minutes, and apply a second application, wait until most of the product has been absorbed.
Remove any excess product with a clean dry cloth; buff up and polish areas with a clean cloth, removing any residue.
DRYING TIME: May vary from floor to floor; product should be touch dry after 2-3 hours, and fully cured within 24-36hours
MAINTENANCE: Maintenance of your floor should be undertaken at regular intervals. To maintain your floor after using Colour Enhancing Impregnator, we recommend maintaining with Professional Care & Maintainer.
SAFETY PRECAUTIONS: Use only in a well ventilated areas; wear appropriate safety gloves, eye protection and respirator when using this product. In confined areas where adequate ventilation is not available, respirators or masks must be worn.